Owner Manual
Table Of Contents
12
WATER SUPPLY CONNECTION
WARNING
To avoid electric shock, which can cause death 
or severe personal injury, disconnect the 
refrigerator from electrical power before con-
necting a water supply line to the refrigerator.
CAUTION
To Avoid Property Damage:
•  Stainless Steel braided tubing is recom-
mended for the water supply line. Water 
supply tubing made of ¼ in. plastic is not 
recommended to be used. Plastic tubing 
greatly increases the potential for water 
leaks, and the manufacturer will not be 
responsible for any damage if plastic tub-
ing is used for the supply line.
•  DO NOT install water supply tubing in areas 
where temperatures fall below freezing.
•  Chemicals from a malfunctioning softener 
can damage the ice maker. If the ice 
maker is connected to soft water, ensure 
that the softener is maintained and work-
ing properly.
IMPORTANT
Ensure that your water supply line connec-
tions comply with all local plumbing codes.
NOTE
Check with your local building authority 
for recommendations on water lines and 
associated materials prior to installing your 
new refrigerator. Depending on your local/
state building codes, Frigidaire recommends 
for homes with existing valves its Smart 
Choice
®
 water line kit 5304437642 (with 
a 6 ft. Stainless Steel Water Line) and for 
homes without an existing valve, Frigidaire 
recommends its Smart Choice
®
 water line 
kit 5304493869 (with a 6’ Polyline Waterline). 
Please refer to www.frigidaire.com/Filters-
-Accessories/Refrigerator-Accessories for 
more information.
Before Installing The Water Supply Line, 
You Will Need:
•  Basic Tools: adjustable wrench, at-blade 
screwdriver, and Phillips screwdriver
•  Access to a household cold water line with 
water pressure between 30 and 100 psi.
•  A water supply line made of stainless steel 
tubing. To determine the length of tubing 
needed, measure the distance from the 
ice maker inlet valve at the back of the 
refrigerator to your cold water pipe, so the 
refrigerator can be moved out for cleaning.
•  A shuto valve to connect the water supply 
line to your household water system. DO 
NOT use a self-piercing type shuto valve.
•  Do not reuse compression tting or use 
thread seal tape.
Ice Maker Models Only
NOTE
Automatic ice makers are optional accessories 
that may be installed in most models at any 
time. Visit www.frigidaire.com/Filters--Acces-
sories/Refrigerator-Accessories for information 
about Ice Maker Kit 117000.










