Installation Instruction

Non-Frigidaire Dual Intake Grille

In cases where the existing sleeve is a non-Frigidaire

sleeve but is installed with a dual intake grille. The existing

grille may be left in place. Make sure the outer 3 ½” to 4 ½”

louvers are angled from the left and right sides of the

sleeve toward the center. (See Fig. 1). This provides

proper flow of outside air into the unit.

From the installation kit, apply two 1” x ¾” x 14” seals along

the flat metal flange of the condenser. (See Fig. 2).

Insert the unit with the seals into the sleeve pushing it all the

way to rear making sure the seal are against the rear grille.

The seals are necessary to reduce recirculation of hot

exhaust air into the intakes which would reduce system

performance.

Fig. 1

Fig. 2

Installation Instructions