Use and Care Manual

9
IMPORTANT
If the condition still exists, try heating
the gasket with a hair dryer with the door
closed. Use Caution and be careful not to
damage the interior door panel or gasket by
applying too much heat.
18. Should open seal condition exist, try to
massage the gasket to make sure it is
seated into the channel.
19. If the open seal condition still exists, it
maybenecessarytoipthegasket.In
this case, remove the gasket from the
door by pulling it out. Rotate the gasket
half a turn (180 degrees). Reinstall the
gasketbyinsertingthecornersrstthen
work towards the middle assuring that it is
fully seated in the channel.
20. Flip toe grille and reinstall.
21. Plug in electrical power cord and turn
refrigerator temperature control to center
position. Adjust setting as necessary.
DOOR REMOVAL/REVERSAL INSTRUCTIONS