Use and Care Manual
8
DOOR REMOVAL/REVERSAL INSTRUCTIONS
9. Unscrew bottom hinge pin using
adjustable wrench. Move hinge pin to
other hole in hinge and tighten with
adjustable wrench.
10. Reverse door handles (see instruction on
next page).
11. Move freezer and refrigerator door stops
to opposite side. Before starting screws,
use an awl to puncture the foam.
12. Position refrigerator door onto bottom
hinge pin and screw center hinge pin
through center hinge into top of door.
Close refrigerator door to help align hinge
hole.
13. Tighten center hinge pin with adjustable
wrench.
14. Remove cabinet and hinge hole plugs and
move to opposite side.
15. Lower freezer door onto center hinge pin.
16. Close freezer door. Lift up on handle side
of door and grasp the thinnest part of
the top hinge cover (which was removed
in Step 2) and insert the thickest part
between the doors on the handle side
approximately 3 inches from the outside
edge. This will ensure proper spacing.
Look for open areas between the
gasket and the cabinet flange.
Gasket should seal against the
cabinet all the way around including top
and bottom
17. Tighten the top hinge screws and check
door gasket for open seal condition (gap
betweengasketandcabinetange).