Use and Care

9
IMPORTANT
Should open seal condition exist, try working
the gasket by hand to make sure it is seated
into the channel.
If the condition still exist, try heating the gasket
with a hair dryer with the door closed. Be
careful not to damage the interior door panel or
the gasket by applying too much heat.
If the open seal condition still exist, it may be
necessarytoipthegasket.Inthiscase,remove
the gasket from the door by pulling it out. Rotate
the gasket half a turn (180 degrees). Reinstall
thegasketbyinsertingthecornersrstthen
work towards the middle assuring that the dart
is fully seated in the channel.

NOTE
In case of future door reversals, save the toe
grille cover not being used.
20. After the screws have been tightened,
replace the top hinge cover.
21. Remove the toe grille cover corresponding
with the door hinge bracket from the toe
grille and attach the opposite toe grille
cover that was saved earlier over the
opening on the side corresponding with
the toe grille support (see Figures A & B).
DOOR REMOVAL/REVERSAL INSTRUCTIONS
A
Toe Grille Cover
Toe
Grille
Support
Anti-tip
Bracket
B
Toe Grille
Cover
Toe Grille
Support
Anti-tip
Bracket
22. Reinstall toe grille with appropriate cover
(some models).
23. Plug in electrical power cord and turn
refrigerator temperature control to center
position. Adjust setting as necessary.
Look for open areas between the
gasket and the cabinet flange.
Gasket should seal against the
cabinet all the way around including top
and bottom
19. Tighten the top hinge screws and check door
gasket for open seal condition (see graphic).