Owner's Guide
5
INSTALLATION
NOTE
If your refrigerator is placed with the door 
hinge side against a wall, you may have to 
allow additional space for the handle so the 
door can be opened wider.
CAUTION
Do not install the refrigerator where the 
surrounding air temperature may fall to 39°F 
(4°C) or below. The refrigerator compartment 
contents may freeze. Do not install the 
refrigerator where the surrounding air 
temperature may reach 110°F (43°C) or above. 
The refrigerator and freezer compartments may 
rise to above normal operating temperatures.
Do not block the toe grille on the lower front of 
yourrefrigerator.Sufcientaircirculationisessential
for the proper operation of your refrigerator.
This Use & Care Guide provides general operating 
instructions for your model. Use the refrigerator only 
as instructed in this Use & Care Guide. Before starting 
therefrigerator,followtheseimportantrststeps.
Location
•  Choose a place that is near a grounded 
electrical outlet. Do Not use an extension 
cord or an adapter plug.
•  If possible, place the refrigerator out of 
direct sunlight and away from the range, 
dishwasher or other heat sources.
•  Therefrigeratormustbeinstalledonaoor
that is level and strong enough to support 
a fully loaded refrigerator.
•  Consider water supply availability for models 
equippedwithanautomaticicemaker.If
you do not hook up water to the refrigerator, 
remember to turn the ice maker off.
Installation
Installation clearances
•  Allow the following clearances for ease 
of installation, proper air circulation, and 
plumbing and electrical connections:
 Sides&Top ⅜inch
 Back  1 inch
or
 2.  Attach toe grille to cabinet.
Guidelines for nal positioning of your 
refrigerator:
•  All four corners of the cabinet must rest 
rmlyontheoor.
•  The cabinet should be level at the front and rear.
•  The sides should tilt ¼-inch (6 mm) from 
front-to-back (to ensure that doors close 
and seal properly).
•  Doors should align with each other and be level.
To install the toe grille:
 1.  The toe grille is packaged with the covers 
installed. Remove the cover on the side 
corresponding with the door hinge bracket.
NOTE
For additional instructions on garage 
installation, refer to “Controls” section.
some models
NOTE
In case of future door reversals, save the 
toe grille cover not being used.










