Use and Care Manual

21
AVOID SERVICE CHECKLIST
Before you call for service, review this list. It may save you time and expense. The list includes common occurrences
that are not the result of defective workmanship or materials in this appliance. This oven is equipped with an electronic
oven controller (some models). Among its many features is a full time oven circuit diagnostics system. The controller
constantly monitors its internal circuitry as well as several crucial oven circuits, to insure they are all operating correctly.
If at any time one of these systems fail, the controller will immediately shut down operation, and will beep and ash an
error code of -F1-, -F3- or -F9- in the display window.
BEFORE YOU CALL
OCCURRENCE POSSIBLE CAUSE/SOLUTION
Oven Control Beeps and Displays
any F code error ( example: -F1-
-F3- or -F9-).
Electronic control has detected a fault condition. Press CLEAR OFF to clear
the display and stop the beeping. Reprogram the oven. If a fault reoccurs,
record the fault number. Press CLEAR OFF and call Service center or another
qualied servicer.
Installation - Oven is not level. Place oven rack in center of oven. Place a level on the oven rack. Contact
installing agent if rack and cabinet cutout ooring are not level.
Kitchen cabinet misalignment may make oven appear to be not level. Be sure
cabinets are square and level. Contact cabinet maker to correct problem.
Entire appliance does not
operate.
Make sure cord / plug is securely plugged into electrical outlet.
Cord/plug is not installed and/or connected. Cord is not supplied with oven.
Contact your dealer, installing agent or authorized servicer.
Service wiring not done. Call the dealer, installing agent or authorized servicer.
Power outage. Check house lights to be sure. Contact your local electric company.
Short in cord/plug. Replace cord/plug.
Controls are not set properly. See instructions to set the controls.
House fuse has blown or circuit breaker has tripped immediately following
installation. House fuse may not be fully engaged. Check fuse and screw or
engage circuit breaker securely.
House fuse has blown or circuit breaker has tripped after the oven has been
installed and previously operating. Call an authorized servicer.
Wall oven is not properly connected to gas supply. Check connection (see
installation instructions).
Make sure gas supply shut-off valve is opened before turning on the oven
after installing the wall oven.
Cannot move appliance easily.
Appliance must be accessible for
service.
Cabinets not square or are built in too tightly. Contact builder or installer to make
appliance accessible.
Carpet interferes with appliance. Provide sucient space so appliance can be
lifted over carpet.
Gas line is hard-plumbed. Have a exible CSA International approved metal
appliance connector installed.
Oven portion of appliance does
not operate.
Be sure regulator gas valve is turned to ON. See installation instructions.
The time of day is not set. The time of day must rst be set in order to operate
the oven.
Be sure the oven controls are set properly for the desired function. See the “Oven
Controls” chapter starting on page 8 and review instructions for the desired cooking
function in this manual or see “Entire appliance does not operate” in this checklist.
Oven light does not work. Burned-out or loose bulb. Follow instructions under Changing Oven Light to
replace or tighten the bulb.