Installation Guide

Installation Instructions

STEP 3 REMOVE TOEKICK

• Remove the 4 toekick screws. Lift off the 2 piece

toekick.

• Measure installation height and dishwasher height.

Extend leveling legs out from the dishwasher base,

1/4" less than installation height.

STEP 2 ADJUST LEVELING LEGS

• Move the dishwasher close to the installation location

and lay it on its back.

Adjust to

Installation

Height

Remove

4 Toekick

Screws

90°

Elbow

Fill

Hose

Thread

Seal Tape

Water

Valve

Bracket

STEP 4 INSTALL 90° ELBOW

• Wrap 90° elbow with thread seal tape.

• Install a 90° elbow onto the water valve.

Figure H

• Do not over tighten 90° elbow, water valve bracket

could bend or water valve fitting could break.

• Position the end of the elbow to face the rear of the

dishwasher.

Figure L

Figure J