Use and Care Manual

14 OPERATING INSTRUCTIONS
Fault Codes
1. If the display reads "AS" or "ES" , a sensor
has failed. Contact your Authorized
Frigidaire® Service Center.
2. If the display reads "EC" , check the
following operating conditions. Outlet
voltage should be 115V±10% and the
surrounding temperature should be with in
the range of 41 °F to 89 °F. Unplug the unit
and plug it in again under normal operating
conditions. If the "EC" code persists,
contact your Authorized Frigidaire® Service
Center.
3. If the display reads “E4”, the
communication between display PCB and
main control PCB is faulty. Contact your
Authorized Frigidaire® Service Center.
NOTE:
• Pump drain hose must be well connected
for this mode.
• If the Pump indicator and Bucket Full
indicator flash simultaneously, after
pressing the Pump button, check if the
pump drain hose in the bucket is installed
properly.
8. To shut the unit down, press the ON/OFF
button.
Note: After a power outage, the unit will
memorize the last setting and return the unit
to the same setting once power is restored.
NOTE:
1. If your unit does not pump water, you
need to check below first: a. Check the
pump is turned on. b. The unit will not
pump untill it reaches the full bucket
point.
2. Please follow the steps described in
“Emptying the Bucket” to remove and
empty the water bucket.
3. Please follow the steps described in “Care
and Cleaning” to clean the unit regularly
to prevent dirt or alge.
4. If the display reads "PU", check the
following operating conditions: a. Make
sure the pump drain hose is well connected.
b. Check that the hose is not blocked,
kinked or frozen. c. Remove and empty the
water bucket to check the bucket pickup
for blockage of dirt or alge. d. Turn o the
unit and restart it under normal operating
conditions. e. Unplug the unit and plug it in
again under normal operating conditions. If
the "PU" code persists, contact your
Authorized Frigidaire® Service Center.