Use and Care Manual

38
CARE AND CLEANING
To clean burner caps:
• Remove caps from burner heads after they have
cooled. Do not clean burner caps in the dishwasher.
Thoroughly dry burner caps immediately following
cleaning including the bottom and inside of cap. Do not
operate surface burners without burner caps properly in
place.
• Lift the burner cap from the burner head. The surface
burner heads are secured to the cooktop and must be
cleaned in place. For proper gas fl ow it may be
necessary to clean the burner heads and slots.
• Clean heavy soils with a plastic scrubbing pad and
absorbent cloth. Do not use abrasive cleaners. They
can scratch porcelain.
To clean burner grates:
• Clean when the grates are cool. Use nonabrasive
plastic scrubbing pad and mild abrasive cleanser.
• Food soils containing acids may affect the finish. Clean
immediately after the grates are cool. Thoroughly dry
grates immediately following cleaning.
Broiler Pan Cleaning Tips
Important: Protective liners--Do not use aluminum foil to
line the oven bottom. Improper installation may result in a
risk of electrical shock or fire.
To make cleaning easier, the bottom of the broiler pan may
be lined with aluminum foil. Do not cover the broiler insert
with foil.
Caution: Use potholders or oven mitts because the broiler
pan may be extremely hot.
• To prevent grease from baking on, remove the broiler
pan from the oven as soon as cooking is completed.
• Pour off grease. Soak the pan in hot, soapy water.
Clean the broiler pan and insert as soon as possible
after each use.
• If necessary, use soap-filled steel wool pads. Heavy
scouring may scratch the insert.
Replacing Oven Lights
Your oven is equipped with interior oven lights that ramp up
gradually when the oven door is opened. The oven lights
can also be turned on when the door is closed by using the
oven light switch located on the control panel.
To remove and replace a light bulb:
Be sure the range is unplugged and all parts are cool before
replacing oven light. Wear a leather-faced glove for protec
-
tion against possible broken glass. Do not allow your fingers
to touch the new bulb when replacing. Use a clean soft cloth
or paper towel to cover the new bulb when installing.
1. Turn electrical power off at the main source or unplug
the appliance.
2. To remove the glass shield, pull the back side of the
shield toward the inside of the oven in a manner to lift it
up from the oven side. The glass shield should come
out easily by pushing a little toward front of the wall
oven (
Figure 35).
3. Replace the halogen appliance bulb.
4. Gently push the glass shield toward the oven wall until it
is firmly seated against the oven wall.
5. Reconnect electrical power to the appliance or turn
power back on.
Figure 34: Broil pan and insert
Figure 35: Light shield and bulb
glass shield
light bulb