Use and Care Manual

22
OVEN CONTROLS
Setting Convection Convert
Pressing the convect convert key automatically converts
the cooking temperature entered for any standard baking
recipe to the lower temperature required for convection
baking.
When first set, convection convert will briefly display a CF
message. The CF message will appear again in the display
as a reminder to check food when the bake time is 75%
complete (
Figure 20). During this time the oven control will
sound one long beep at regular intervals until the set bake
time has finished.
To add convection convert to convection bake using
default oven temperature of 350°F:
1. Press convect key once for convection bake.
2. Press start. The convection fan will turn on after 6
minutes.
3. Press convect convert.
4. To cancel convection convert at any time, press off.
To program oven for convection convert with oven
default temperature of 350°F and to shut-off after 30
minutes:
1. Press convect key once for convection bake.
2. Press start. The convection fan will turn on after 6
minutes.
3. Press bake time.
4. Enter 3 0 using numeric keypad.
5. Press start.
6. Press convec convert.
7. To cancel Convection Convert at any time, press off.
Important note:
• Convection convert may only be used with the Convec-
tion Bake function.
• When using convection convert feature, bake time
reductions may vary depending on the oven set temper
-
ature.
• The convection fan will begin rotating 6 minutes after
Convection Bake, Convection Roast, or Quick Preheat
has been activated.
• If the oven door is opened when any convection
function is active, the convection fan will stop rotating
until the oven door is closed.
• Do not open the oven door often. Opening the door will
reduce the temperature in the oven and may increase
the cooking time necessary for best results.
To set the oven for convection bake with a standard
baking recipe temperature of 400°F:
1. Arrange interior oven racks.
2. Press convect. Convect and bake will flash and 350
will appear in the display.
3. Press 4 0 0. Convect and bake will keep flashing and
400° will appear in the display.
4. Press start.
5. Set bake time or delay start if needed. For delay start
or bake time instructions, see
page 21.
6. Press convect convert, and the oven temperature
displayed will be 25°F lower than the original set
temperature of 400°F. The actual oven temperature and
the fan icon will be displayed. A beep will sound once
the oven temperature reaches 375°F.
7. Place food in the oven.
Figure 20: Check Food reminder shown in display.
Pressing off will stop the feature at any time.
NOTE