Installation Guide

15
36" GAS RANGE INSTALLATION INSTRUCTIONS
10.2
Oven Burner Flame Adjustment
The approximate oven burner ame length is 1 inch
(distinct inner cone of blue ame).
To determine if the oven burner ame is proper, remove
the oven bottom and burner bafe and set the oven to
bake at 300°F.
To remove the oven bottom, remove the oven racks
and the ladder racks. Slide the oven bottom forward to
disengage the back tab. Lift and slide back to disengage
front of oven bottom from oven front frame. Pull the oven
bottom out of the cavity. The bafe is attached to the
oven bottom and requires no further disassembly.
If the ame is yellow, increase air shutter opening size
(see "2" in Figure 24). If the entire ame is blue, reduce
the air shutter opening size.
To adjust ame loosen lock screw (see "3" in Figure 24),
reposition air shutter, and tighten lock screw. Replace
oven bottom.
10
Adjusting Oven Burners
10.1
Electric Ignition Burners
Operation of electric igniters should be checked after
range and supply line connectors have been carefully
checked for leaks, and range has been connected to
electric power. The oven burner is equipped with an
electric control system as well as an electric oven burner
igniter. If your model is equipped with a waist-high broil
burner igniter, it will also have an electric burner igniter.
These control systems require no adjustment. When
the oven is set to operate, current will ow to the igniter.
It will "glow" similar to a light bulb. When the igniter
has reached a temperature sufcient to ignite gas, the
electrically controlled oven valve will open and ame will
appear at the oven burner. There is a time lapse from
30 to 60 seconds after thermostat is turned ON before
the ame appears at the oven burner. When the oven
reaches the display setting, the glowing igniter will go
off. The burner ame will go "out" in 20 to 30 seconds
after igniter goes "OFF". To maintain any given oven
temperature, this cycle will continue as long as the
display is set to operate.
After removing all packing materials and literature from
the oven:
1. Set the oven to BAKE at 300°F. See Use & Care
Guide for operating instructions.
2. Within 60 seconds the oven burner should ignite.
Check for proper ame (see 10.2), and allow the
burner to cycle once. Reset controls to off.
3. If your model is equipped with a waist-high broiler
burner, set oven to broil. See Use & Care Guide for
operating instructions.
4. Within 60 seconds the broil burner should ignite.
Check for proper ame. Reset controls to off.
Air Shutter
Air Shutter
Waist-High Burner
Lower Oven
Bottom
removable)
Lower
Oven Burner
Bafe
(removable)
Figure 23: Oven Burners
Figure 24: Oven Burner Adjustments
Oven Burner Tube
Orice Hood
Lock Screw
Air Shutter
3
2
1
10.3
Broil Burner Flame Adjustment
The approximate ame length of the burner is 1 inch
(distinct inner cone of blue ame). To determine if the
broil burner ame is proper, set the oven to broil. If ame
is yellow, increase air shutter opening size (see "2" in
Figure 24). If the entire ame is blue, reduce the air
shutter opening size. To adjust, loosen lock screw (see
"3" in Figure 24), reposition air shutter, and tighten lock
screw.