Specification Guide

NOTE: Chassis requires WSE sleeve (sold and shipped separately)
OPTIONAL ACCESSORIES
IMPORTANT:
Operating the air conditioner
with incorrect rear grille or
without Bafe Adapter Kit
(on 19 ¾" deep sleeve) will
recirculate discharge air and
cause compressor overload
to trip.
This will cause the unit to shut
down temporarily and may
lead to premature compressor
failure.
CORRECT Vertical Louvers
INCORRECT Horizontal Louvers
WSE SLEEVE/ EXTERIOR GRILLES
Optional Architectural Grille- AG
Premium extruded aluminum grille.
Standard Grille
Premium, expanded metal grille
with powder coat paint. Ships
with WSE sleeve.
INSTALLATION ACCESSORIES
DK / Drain Kit
Installed at the back of the unit and allows for
attachment to condensate disposal system,
if necessary or desired.
IDK / Internal Drain Kit
New construction applications
where a condensate drain system
has been built into the wall interior.
BAK / Bafe Adapter Kit
Necessary when installing in a
sleeve deeper than 16 ¾" deep,
such as Fedders B sleeve
(19 ¾" deep).
Height W idth Depth
Height
of Front
Width of
Front
Depth
with
Front
Minimum
Extension Into
Room with
Front
15 ¾" 26 ½" 21" 17 ¼" 27 ½" 23 ¼" 7 ½"
CHASSIS DIMENSIONS WSE SLEEVE DIMENSIONS
Height W i d t h Depth
Depth
with
Front
Minimum
Extension
Outside
Thru-the-wall
Finished Hole
Height Width Max. Depth
16 ¾" 27" 16 ¾" 24 ¼"
9
/ 16 " 17 ¼" 27 ¼" 15
5
/ 16 "
WSE Wall Sleeve
Ships with standard grille (shown
above) and standard galvanized
steel inner panel and painted steel
outer panel.
WSE sleeve Steel inner panel Outer weather panel