Service & Parts Manual (2019, 2020, 2021, 2022)
Table Of Contents
- INTRODUCTION
- SPECIFICATIONS
- OPERATION
- ROUTINE MAINTENANCE
- REMOVE AND INSTALL THE CHASSIS
- R-410A SEALED SYSTEM REPAIR
- COMPONENT TESTING
- Hermetic Components Check
- Reversing Valve Description And Operation
- Testing The Reversing Valve Solenoid Coil
- Checking The Reversing Valve
- Replace The Reversing Valve
- Touch Test Chart : To Service Reversing Valves
- Compressor Checks
- Compressor Replacement
- Fan Motor
- Capacitors
- Heating Element
- Drain Pan Valve
- Testing the User Interface and Electronic Control Board
- Thermistors Description
- Electronic Control Board Identification
- Replace the Electronic Control Board
- Replace the User Interface
- TROUBLESHOOTING
- WIRING DIAGRAMS
- PARTS CATALOG
- Available Accessories
24 PB
OPERATION
User Interface
The Lock Menu continued
The ON on the right side of the display shows the lock function is active. See Figure 326.
To go back into the menu, select the menu button again. See Figure 306.
Enter the password in the same manner it was created. See Figure 327.
Entering the correct password will give the user access to all of the sub-menus. See Figure 328
Accessing the lock menu will allow you to toggle lock OFF if needed. See Figure 329
Figure 326
MENU RETURN
Figure 327
MENU RETURN
Figure 328
MENU RETURN
Figure 329
MENU RETURN