Installation Instruction Accessory Guide

STEP 2. Install Grille — See Figure 2.
A. Screw the 4 all thread studs into the 4 holes in the Architectural Louvered Grille. Pass
grille through rear opening. Locate the grille such that the louvers are pointing to the
outside and down. The mounting holes in the left and right vertical rails must match
up with the open holes in the shell tabs. Fasten the grille with the washers and nuts
provided.
B. Remove the zip tie from the louver.
C. Slide the air conditioner chassis into the sleeve according to the chassis instructions.
FIGURE 2
93063000_00 (2-13)