Installation & Operation Manual (2019, 2020, 2022)

32
Accessories
PXAA
New Construction Accessories
PDXWSA
PDXWSEXT18
PDXWSEXT24
PDXWSEXT
WALL SLEEVE Galvanized zinc coated steel is prepared in an 11-
step process, then powder coated with a polyester nish and cured
in an oven for exceptional durability. The wall sleeve is insulated for
sound absorption and thermal efciency, 16" H x 42" W x 13
3
/4" D.
DEEP WALL SLEEVE For walls up to 17
1
/2" D.
DEEP WALL SLEEVE For walls up to 23
1
/2" D.
CUSTOM DEEP WALL SLEEVE One piece extended wall sleeve for walls
from 13
1
/4" to 25
1
/2" D are available by special order.
PXSE
SLEEVE EXTENSION RETROFIT KIT Galvanized zinc coated steel, 2
3
/8"
sleeve extension attached to the room side of the sleeve to allow for the
installation of a PZ-Series Friedrich PTAC in a T-Series sleeve.
PXGA
GRILLE Standard, stamped aluminium, anodized to resist chalking and oxi-
dation.
PXAA
PXBG
PXSC
ARCHITECTURAL GRILLES C o ns is t o f h ea v y- g au ge 6 0 6 3-T5 a lu min um
alloy: 42" W x 16" H x 1
1
/8" D
PXAA – Clear, extruded aluminum
PXBG – Beige acrylic enamel
PXSC – Also available in custom colors.
PXDR10
CONDENSATE DRAIN KIT Attaches to the bottom of the wall sleeve for in-
ternal draining of condensate or to the rear wall sleeve ange for external
draining. Recommended on all units to remove excess condensate. Pack-
aged in quantities of ten.
PXCJA
CONDUIT KIT WITH JUNCTION BOX Hard wire conduit kit with juncti on b ox
for 208/230V and 265V units (subbase not required). Kit includes a
means of quick disconnect for easy removal of the chassis. *Required
for 265V installations.
PDXDAA
LATERAL DUCT ADAPTER Attaches to the Friedrich PTAC/PTHP unit to di-
rect up to 35% of the total airow to a second room. The unit-mounted duct
plenum features a front-mounted aluminum grille that has two positions
to provide the most optimal air direction. The air may be directed to either
the left or the right of the unit through the supplied 3
1
/2 H" x 7 W" x 47" L
plenum. Plenum may be cut to length by the installer. Kit includes duct
plenum, front grille, 47" duct extension, duct discharge grille, duct end cap
and all necessary mounting hardware.
PDXDEA
L
ATERAL DUCT EXTENSION Additional 3
1
/2 H" x 7" W x 47" L plenum for
use with the LATERAL DUCT ADAPTER. A maximum of 3 duct exten-
sions total may be used. Note: Ducted airow is reduced as duct length is
increased.
PXGA
Deep wall sleeve PDXWSEXT18 shown with weather panel
PDXWSA