Product Profile (2021)

11
Architectural Louver Installation (PXAA)
INSTALLATION
1. Screw a threaded metal stud into each of the
holes at the four corners of the louver.
2. From inside the building, grasp the louver
at the vertical supports and maneuver the
louver through the wall sleeve. Pull towards
you until the threaded studs are inserted into
the four holes of the wall sleeve.
3. While holding the louver with one hand, start
washers and nuts on each of the four studs.
Tighten the nuts securely.
External Drain
PXDR10 DRAIN KIT
Internal Drain Kit Location and Installation (PXDR10)
ACCESSORY INSTALLATION
When using an external drain
system, the condensate is removed
through either of two drain holes on
the back of the wall sleeve. Select
the drain hole which best meets
your drainage situation and install
the drain kit. Seal o󰀨 the other with
a cover plate.
Place the drain tube through the
gasket and the mounting plate with
the ange toward the wall sleeve.
Attach the drain tube assembly to
one of the two drain holes at the rear
of the wall sleeve. The large ange
on the mounting plate is positioned
at the bottom of the sleeve facing
toward the sleeve. When the drain
tube is positioned at the desired
angle, tighten the screws.
CAUTION
Bodily injury can be caused by louvers
falling from a building during installation. It is
recommended that a safety line be attached
to the louver and an anchor point inside the
building during installation.
FRP01
1
DRAIN TUBE
SIDE VIEW
FRONT VIEW
WALL SLEEVE
OPTIONAL AREA
PREFERRED AREA-
NO FOAM INSULATION
NOTE: IF THE DRAIN MUST BE
LOCATED IN THE OPTIONAL
AREA, THE FOAM INSULATION
MUST BE CUT AWAY AND
REMOVED TO ALLOW ACCESS
TO THE DRAIN.
NUT
MOUNTING
PLATE
GASKET
SCREW
3"
OPTIONAL
AREA MUST BE 18”-21” CENTERED
FROM SIDEW
ALLS TO ENSURE DRAINAGE
FRP012
FOAM
GASKET
OVERFLOW
SLOTS
DETAIL B
DETAIL A
COVER
PLATE
FOAM
GASKET
SCREWS
½” O.D. TUBE
MOUNTING
PLATE
NUT