Accessory KWIKQA Manual (2019)
ManualsBrandsFriedrich ManualsAir ConditionersKuhl Plus Series Smart Heat Pump Window or Wall Air Conditioner with 10000 Cooling BTU, 8800 Heating BTU, 450 sq. ft. Cooling Area, 300 CFM, 4 Cooling Speed, Remote Controller, 115 Volts, 10.9 EER Remote Control, Wi-Fi Enabled, Timer, Auto Restart, Washab
Table Of Contents
21
FRR201
FACTORY SETTING WITH LEFT-SIDE
CORD PLACEMENT
FRR202
NEW CORD ALIGNMENT FOR ROUTING CORD
EXIT TO THE RIGHT OF UNIT
FRR099
CLOSE-UP OF
CORD UNDER
LEFT MOUNTING
SCREW
EMBOSSMENT
STEP 2. Route the cord along bottom inside of the unit (See Figures 25
and 26), under the lower left mounting screw embossments
and exit the cord through right side cord opening (See Figure
26) of the decorative front cover. Decorative front cover will
keep cord in place.
STEP 3. Reinstall the 4 screws removed earlier to secure decorative
front cover with cord exiting to the front bottom of the unit. (4
screws RETAINED FROM STEP 1) and re-connect the power
cable harness (disconnected in STEP 1).
Figure 25
Figure 26
Figure 27
For additional safety, your unit is equipped with EntryGard™ protection,
a feature that helps prevents kick-in intrusions. To engage this feature,
use 2 supplied 1/2" screw (E in parts list) to secure decorative front
cover to sleeve. (See Figure 28 for screw hole locations) .
EntryGuard Security Lock
Figure 28