Accessory KWIKQA Manual (2019)
ManualsBrandsFriedrich ManualsAir ConditionersKuhl Plus Series Smart Heat Pump Window or Wall Air Conditioner with 10000 Cooling BTU, 8800 Heating BTU, 450 sq. ft. Cooling Area, 300 CFM, 4 Cooling Speed, Remote Controller, 115 Volts, 10.9 EER Remote Control, Wi-Fi Enabled, Timer, Auto Restart, Washab
Table Of Contents
20
WARNING
Electrical Shock Hazard
Make sure your electrical receptacle has the
same configuration as your air conditioner’s
plug. If different, consult a Licensed Electrician.
Do not use plug adapters.
Do not use an extension cord.
Do not remove ground prong.
Unplug unit prior to performing any service.
Always plug into a grounded 3 prong oulet.
Failure to follow these instructions can result in
death, fire, or electrical shock.
STEP 1. Remove the decorative front cover. (See A thru D and Figures
24A and 24B below)
Cord Routing Change
Unplug unit.
A. Open the decorative front cover.
B. Locate and disconnect electronic control power cable harness.
C. Remove 4 screws attaching decorative front cover.
Save to reinstall later..
D. Remove decorative front cover. Store in a safe place to
reinstall later. (no image).
A.
B.
C.
Figure 24A
Figure 24B
Your Kühl Q unit will come with the power cord already installed and routed
to the left side of the unit.
For convenience and optimum appearance the direction of the power
cord can be changed from left to right by following the procedure below.
Select the exit location on the left or right based on proximity to the power
outlet. (See Figure 23)
Figure 23