Service & Parts Manual (Non Q) (2019, 2020, 2021, 2022)
Table Of Contents
- INTRODUCTION
- SPECIFICATIONS
- OPERATION
- ROUTINE MAINTENANCE
- REMOVE AND INSTALL THE CHASSIS
- R-410A SEALED SYSTEM REPAIR
- COMPONENT TESTING
- Hermetic Components Check
- Reversing Valve Description And Operation
- Testing The Reversing Valve Solenoid Coil
- Checking The Reversing Valve
- Replace The Reversing Valve
- Touch Test Chart : To Service Reversing Valves
- Compressor Checks
- Compressor Replacement
- Fan Motor
- Capacitors
- Heating Element
- Drain Pan Valve
- Testing the User Interface and Electronic Control Board
- Thermistors Description
- Electronic Control Board Identification
- Replace the Electronic Control Board
- Replace the User Interface
- TROUBLESHOOTING
- WIRING DIAGRAMS
- PARTS CATALOG
- Available Accessories
43 PB
A
ROUTINE MAINTENANCE
Standard Filter Removal / Installation Instructions
1. Swing the door open, See Figure 402, and remove the lter by grasping the lter grip and pushing the lter holder
upward and outward. See Figure 403.
2. Slide the lter grip out from the lter as shown in Figure 404.
NOTE: Make sure the front frame with the mesh lter is facing you.
3. Swing the front frame open. See Figure 405. Clean the front frame by washing the dirt from the lter. Use a mild soap
solution if necessary. Allow lter to dry.
4. Install the lter grip back into the lter by sliding it into the lter.
NOTE: The lter handle slides into the frame in only one direction. If the tab in the frame stops the handle from sliding in, slide
the handle from the other direction. DO NOT FORCE THE HANDLE INTO THE FRAME.
Figure 402
Figure 403
Figure 404
Figure 405
FRONT
FRAME
WITH