/
Table of Contents Air Conditioner Safety ......................................................................................................................................................1 Installation Requirements ...............................................................................................................................................3 Tools and Parts.....................................................................................................................................
General Instructions This Installation and Operation Manual has been designed to insure maximum satisfaction in the performance of your unit. For years of trouble-free service, please follow the installation instructions closely. We cannot overemphasize the importance of proper installation. We have added new information to the basic instructions to help you achieve success. WARNING WARNING Refrigeration system under high pressure.
K K.
Window installation Electrical Requirements Window opening measurements: 27"min. to 42" max. (76.2 cm to 101.6 cm) opening width (A). 20" min. (50.8 cm) opening height (B). A B A.27" min. (76.2 cm) B . 20" min. (50.8 cm) Ground wire must be connected to ground screw located in lower right corner of air conditioner when air conditioner is in cabinet. The electrical ratings for your air conditioner are listed on the model and serial number (nameplate) label.
Recommended grounding method This air conditioner must be grounded. This air conditioner is equipped with a power supply cord having a grounded 3 prong plug. To minimize possible shock hazard, the cord must be plugged into a mating, grounded 3 prong outlet, grounded in accordance with all local codes and ordinances. If a mating outlet is not available, it is the customer' s responsibility to have a properly grounded 3 prong outlet installed by a qualified electrical component installer.
Window Installation (on some models) NOTES: ■ Handle air conditioner carefully and gently. ■ Be sure your air conditioner cabinet does not fall out of the opening during installation or removal. ■ The place where the power cord exits the air conditioner should be no more than 4 ft (122 cm) from a grounded 3 prong power outlet. ■ Do not block the louvers on the front panel. ■ Do not block the louvers on the outside of the air conditioner. Bottom view A B A. Curtain housing B.
7
12
■ 3. Insert cabinet into the framed wall opening. the top of the cbine should extend ¾" (19.1 mm) into the room. If there is trim, the cabinet should extend ¾" (19.1 mm) past the trim. Use 2" x 4" or thicker lumber for wood frame. A B B A C A. Outside width B. Outside height C. Depth 4. Apply wood preservative to the outside exposed surface. 5. Insert the frame in the wall opening. Square and level frame. 6. Attach frame securely to the wall. A. ³⁄₄ " (19.1 mm) extending into room B.
and 2-#9.5X 3/8”pan-head Phillips screws, attach front of panel to chassis.
Starting Your Air Conditioner—Digital Control Temperature Money Saver® Auto Swing Press, or press and hold, the plus button to raise the temperature 1º until it reaches 90ºF (32.2ºC). Timer F 0 F 0 Temp/Hour Temp/Hour Hr. POWER Hr. High Cool Mode Med Fan Speed Low Fan Only Press, or press and hold, the minus button to lower the temperature 1º until it reaches 60ºF (15.5ºC). 1. Press POWER to turn on air conditioner.
To raise the temperature: To operate air conditioner with remote control Press the plus button to raise the temperature. Each time you press or hold the plus button, the temperature will go up 1º until it reaches 90°F (32.2°C). NOTE: Remote control may vary in appearance. To lower the temperature: Press the minus button to lower the temperature. Each time you press or hold the minus button, the temperature will go down 1º until it reaches 60°F (15.5°C).
Air Conditioner Care Your new air conditioner is designed to give you many years of dependable service. This section tells you how to clean and care for your air conditioner properly. Call your local authorized dealer for an annual checkup. Remember… the cost of this service call is your responsibility. Cleaning the Front Panel 1. Turn off air conditioner. 2. Remove the air filter and clean it separately. See “Cleaning the Air Filter.” 3. Wipe the front panel with a soft, damp cloth. 4.
Air conditioner power supply cord trips (Reset button pops out) ■ Disturbances in your electrical current can trip (Reset button will pop out) the power supply cord. Press and release RESET (listen for click; Reset button will latch and remain in) to resume operation. ■ Electrical overloading, overheating, cord pinching or aging can trip (Reset button will pop out) the power supply cord.
Friedrich Air Conditioning Company 10001 Reunion Place, Suite 500 78216 (800)541-6645 www.friedrich.com ROOM AIR CONDITIONERS LIMITED WARRANTY FIRST YEAR ANY PART: If any part supplied by FRIEDRICH fails because of a defect in workmanship or material within twelve months from date of original purchase, FRIEDRICH will repair the product at no charge, provided room air conditioner is reasonably accessible for service.
66129903813
