Installation and Operations Manual (2019, 2020, 2021)

OFFSET

STOOL

SILL

INTERIOR

WALL

EXTERIOR

WALL

Air conditioner

Bottom channel

23” to 36”

660mm to 914mm

16”

406mm

1. This air conditioner is designed to be installed

In a standard double-hung window with a window

width between 23” and 36” (660mm-914mm).

2. The air conditioner can be installed without the

accordion panels fit in a narrow window opening.

3. The lower sash ( the lower part of the window that

moves up and down) must allow for 16” of vertical

clearance when open.

4. All supporting parts must be secured to firm wood,

masonry, or metal.

5. The electrical outlet must be within reach of the

power cord.

Window preparation

ALL INFORMATION AND THE TECHNICAL SPECIFICATIONS PRESENTED IN THIS USER’ S MANUAL ARE THE PRESENTATION

OF THE MANUFACTURE. PLEASE READ AND FOLLOW THESE INSTRUCTIONS CAREFULLY.

How to Install

NOTE:This is necessary for proper condensed water

utilization and drainage. If you are not using the Side

Panels for any reason, this pitch to the rear muse be

maintained!

Remove the air conditioner from the box and place on a

hard flat surface, as floor, a bench or a table. There is a

Left and Right Window Filler Panel - be sure to use the

proper panel for each side. When installed the flange for

securing the panel in place to the window sill will be facing

into the room.