User's Manual

Operation
13
Insert the plug of the connection lead into
the plug socket with protective earth
c o n t a c t . W h e n t h e r e f r i g e r a t o r
compartment door is opened, the internal
lighting is switched on. After the fridge has
been placed in position, wait for 5 minutes
before electricity is supplied. Don’t store
anything until the temperature inside the
fridgebecomeslowenough.
Startingupandtemperatureregulation
The temperature selector knob is located
onthetopoftherefrigeratorcompartment.
Setting0means:
Setting1means:
Setting7(end-stop)means:
Off.
Clockwise rotate the knob to turn on the
appliance.
Highesttemperature,warmestsetting.
Lowesttemperature,coldestsetting.
Important! Normally we advise you select
setting of 2 or 3 0r 4, if you want the
temperature higher or colder please turn
the knob to warmer or colder setting
accordingly. When you turn the knob to
colder which can lead to the more energy
efficiency-Otherwise, it would result the
energy-consuming.
Important!
Reason:
High ambient temperatures
(e.g. on hot summer days) and a cold
setting (position 6 to 7) may cause the
compressor to run continuously or even
non-stop!
when the ambient temperature is
h i g h , t h e c o m p r e s s o r m u s t r u n
continuously to maintain the low
temperatureintheappliance.
Changingthelightbulb
Bulb
Bulbcover
Screw
ControlBox
Bulbfixedblock
Warning! If the light bulb is
damaged.DONOT CHANGIT BY
THEUSER!
Changing the light bulb carry out by
inexperienced persons may cause injury
or serious malfunctioning. It must be
replaced by a qualified persons in order to
avoid a hazard. Contact your local Service
ForceCenterforhelp.
Before changing the light bulb, switch off
the appliance and unplug it, or pull the
fuseorthecircuitbreaker.
Light bulb data: 220-240 V, LED
MAX.1.5W.
To switch off the appliance, set the
temperatureregulatortoposition “0”.
Unplugthemainsplug.
Press the light bulb cover, and slide it
backwards.
Tochangethelightbulb,undothescrew.
Remove the bulb fixed block, change the
defectivelightbulb.
Refit the bulb fixed block, the light bulb
coverandthescrew.
Puttherefrigeratorbackintooperation.