User's Manual

-consuming.
13
Operation
Starting up and temperature regulation
The temperature selector knob is located
on the top of the refrigerator compartment.
Setting 0 means:
Off.
Clockwise rotate the knob to turn on the
appliance
Setting 1 means:
Highest temperature, warmest setting.
Setting 7 (end-stop) means:
Lowest temperature, coldest setting.
Insert the plug of the connection lead into
the plug socket with protective earth
contact. When the refrigerator
compartment door is opened, the internal
lighting is switched on.After the fridge has
been placed in position,wait for 5 minutes
before electricity is supplied.Don't store
anything until the temperature inside the
fridge becomes low enough.
Important! Normally we advise you select
setting of 2 or 3 or 4, if you want the
temperature higher or colder please turn the
knob to warmer or colder setting accordingly.
When you turn the knob to colder which can
lead to the more energy efficiency.
Otherwise, it would result in more energy
Important! High ambient temperatures (e.g.
on hot summer days) and a cold setting
(position 6 to 7) may cause the compressor
to run continuously or even non-stop!
Reason: when the ambient temperature is
high, the compressor must run continuously
to maintain the low temperature in the
appliance
Warning! If the LED light is
damaged. DO NOT CHANG IT BY
THE USER!
Changing the LED light carry out by
inexperienced persons may cause injury or
serious malfunctioning. it must be replaced
by a qualified persons in order to avoid a
hazard. Contact your local Service Force
Center for help.
Before changing the LED light, switch off
the appliance and unplug it, or pull the
fuse or the circuit breaker.
LED Light data: 220-240 V,max.1.5W.
To switch off the appliance, set the
temperature regulator to position “0”.
Unplug the mains plug.
Press the Lampshade, and slide it
backwards.
To change the LED light, undo the screw .
Remove the bulb fixed block, change the
defective LED light .
Refit the bulb fixed block, the LED light
cover and the screw.
Put the refrigerator back into operation.
Changing the light bulb
LED light
Lampshade
Screw
Control Box
Bulb fixed block
0
1
2
3
4
5
6
7