Blue-Tube XL Owners Manual

Duct Mount Installation

Optional Mounting Magnets

UV lamps

System Conguration A: In-Line With Air Flow (pre-assembled parts are ready for this conguration)

System Conguration B: Diagonal To Air Flow

1. Cut an access panel into the duct. If necessary cover high exposure

areas with UV-resistant reective tape or similar material.

2. Remove hardware then cut conduit to t duct.

3. Re-attach hardware in the conguration below.

4. Adjust the angle of the mounting brackets so the UV lamps will

cross the air-stream diagonally. Mount the frame-work into the

duct using the self-tapping screws or optional mounting magnets.

Conguration A Assembled

Conguration B Assembled

Air Flow

1. Cut an access panel into the duct. If necessary cover high exposure

areas with UV-resistant reective tape or similar material.

2. If needed, loosen or remove hardware then cut conduit to t duct.

3. Mount the frame-work into the duct using the self-tapping screws or

optional mounting magnets.

UV lamps

Optional

Mounting

Magnets

C C

A B