Specification Sheet

INSTALLATION

INSTRUCTIONS

Single hole faucet

Cleaning

Before use: Unscrew the Aerator and allow the water to run freely for 5 minutes. Then screw the filter back in place.

Periodically: Unscrew the Aerator and remove. Rinse it with running water until any loose debris is cleared. Then replace the Aerator

and tighten.

Aerator

FFT1041

●

We recommend that this product is installed by a qualified professional contractor.

●

Please check this product immediately to ensure that it has not been damaged and is complete.

●

Please flush the water system to ensure that no debris or any other impurities can enter the taps.

Turn off water supply before commencing work

● Please read these instructions carefully and keep for future reference.

Important

PAGE 1
INSTALLATION INSTRUCTIONS FFT1041 Single hole faucet Important We recommend that this product is installed by a qualified professional contractor. ● Please check this product immediately to ensure that it has not been damaged and is complete. ● Please flush the water system to ensure that no debris or any other impurities can enter the taps. ● Turn off water supply before commencing work. ● Please read these instructions carefully and keep for future reference.
PAGE 2
7″ Dimensions 4 3/8″ Unit:inches Installation Max 1.1″ 9″ 11 5/8″ 5 3/4″ GRUB SCREW CAP HANDLE CARTRIDGE COVER RETAINING NUT FAUCET CARTRIDGE PEDESTAL FAUCET SUPPLY LINES WASHER To remove the cartridge. RUBBER WASHER PLASTIC WASHER FEMALE SCREW First shut off the water supply to the tap. 1: Unscrew the handle from the cap. 2: Loosen the grub screw in cap. 3: Take off the cap, unscrew the cartridge cover. 4: Unscrew the retaining nut.