Fault Code Guide

13.3 Using a chain, secure the transmission to
the jack.
14. Remove the 16-mm transmission mounting cap-
screws that attach the timing case to the bell
housing. See Fig. 12.
14.1 Remove the eleven transmission mounting
capscrews.
14.2 After removing the transmission, insert the
capscrews into the holes in the timing
case, rather than in the bell housing.
CAUTION
Do not allow the rear of the transmission to drop,
and do not allow the transmission to hang un-
supported. Keep the flange of the bell housing
parallel (all the way around) to the flange of the
timing case, until the input shaft is clear of the
flywheel. Taking these precautions will prevent
damage to the input shaft, flywheel, and clutch.
15. After making sure that the transmission is firmly
secured and well supported, remove the trans-
mission from the vehicle. See Fig. 13.
03/01/99
f261014
1
2
3
1. Transmission
2. Support Plate
3. Jack
Fig. 11, Supporting the Transmission
01/29/99
f261011
Fig. 12, Capscrews Left in the Timing Case
01/29/99
f261013
Make sure that the transmission is firmly secured and
well supported.
Fig. 13, Transmission Ready To Remove
Mercedes-Benz Manual Transmission 26.04
Transmission Removal and Installation
Business Class M2 Workshop Manual, Supplement 8, September 2005100/4