Fault Code Guide

8. Bend back the nut retainers and remove the
power take-off unit (PTO), if installed. See Fig. 9.
9. If the vehicle is equipped with optional dual fuel
tanks, remove the fuel cross-over line and its
support between the tanks.
10. Disconnect the electrical cable from the speed-
ometer sensor and mark it with a paint pen for
ease of installation. See Fig. 7.
11. Remove the battery cable bracket(s) around the
transmission and move the battery cables out of
the way. See Fig. 10.
12. Remove the exhaust clamp at the exhaust elbow.
For ease of transmission removal and installa-
tion, move the exhaust pipe to the side and out
of the way.
13. Support the transmission with a jack. See
Fig. 11.
13.1 Position a transmission jack under the
transmission and raise its support plates
against the base of the transmission.
13.2 Adjust the support plates to cradle the
transmission.
06/05/2001
1
2
3
f261009
1. Speedometer Sensor
2. Fuel Line
3. Standoff Bracket
Fig. 7, Fuel Line Standoff Bracket and Speedometer
Sensor
05/24/2001
f261107
1
2
3
1. M8 Bolts
2. Bleed Valve
3. Slave Cylinder
Fig. 8, Hydraulic Clutch Slave Cylinder
05/14/2001
f261105
Bend back the nut retainer (arrow).
Fig. 9, Power Take-Off Unit (PTO) Nut Retainers
05/14/2001
f261106
1
2
3
1. Battery Cable
2. Battery Cable Clamp
3. Battery Cable Bracket
Fig. 10, Battery Cable Routing
Mercedes-Benz Manual Transmission 26.04
Transmission Removal and Installation
Business Class M2 Workshop Manual, Supplement 8, September 2005 100/3