User Manual

P  S  i 
EN
6.Use "nut (H)" to secure the "motor clip (D)" and the "rotor (F)".
7 .Cover the "spinner (I)", and use "screw (J)" to secure it.
8.Put the installed "EDF (K)" in the fuselage and secure it with 4
"screws (L)".
1. Fit "motor (A)" into "ducted fan housing (B)".
2. Secure the motor with 4 "screws (C)".
3. lSlide the "motor clip (D)" over the motor shaft.
4. Put the "fixed disk (E)" on the "motor clip (D)".
5. Put the "rotor (F)", "spacer (G)" on the "motor clip (D)".
\
J



A
K

 







&

Center of Gravity
&



 

 


 B  : 


(3.54-3.94 in.)
Rebel 70 EDF Jet


-6-
When tightening the nut (G), take care
not to over tighten it as it may cause damage
to the rotor (F).
Once the battery is connected to the
ESC, take care not to touch them or the EDF
as this might c
ause accidental injury. When
testing the EDF, use a proper test stand.