User Manual

Elevator Installation
1. Use the 2 screws (PA3x40mm) to secure the
elevator to the tail of the fuselage.






, 
 


l�eomm



 
n


Rudder Installation
 
1. Use your servo tester or radio to center the
servo.
2. Use the supplied glue to attach the 9g servo and
control horn to the rudder.
3. Adjust the push rod length so that the rudder is
in the neutral position when the pushrod is
connected
4. When the pushrod is properly adjusted, attach
the clevis to the rudder control arm.



 


,
! � t.
 
 


-
...
 
A- Screws (PWA3x8mm)
B- Screws (PA2x6mm)
C- Plastic rudder mount




 M 

PWA3x8mm
(2pcs)

EN
A- Screws (3xPA3x40mm)
1. Using the diagram as a guide, use the 2
screws (PWA3x8mm) to attach the rudder
to the plastic rudder mount.
2. Use the 5 screws (PA2x6mm) to secure the
rudder to the fuselage.
PA2x6mm
(5pcs)