Note Product basic information Package list PNP Assembly instructions Install fuselage install engine compartment Install horizontal. vertical stabilizer install main wing Install wingtip Install decorated parts Install battery Push rod instructions Important additional notes Center of gravity PNP Parameter sating Control direction test Dual rates Pr-installed component overview Servo direction Motor specification Control box wiring diagram BEER PE RAE SE BFE PHP SEAR ME BEE TR.
1.This is not a toy] Ops rater should have a certain experience, beginners should operate under the guidance of professional players. 2 Before install, pleases read through the instructions carefully and operate strictly under instructions. 3.Cause of wrong operation Freeing and ifs vendors wil not be held responsible for any losses, 4 Model planes’ players must be on the age of 14 years old. 5.
As the photo show © 1.Use glue fo fix the fuselage tail on the fuselage. As the photo show 1. Install the engine compartment on the rear of the fuselage with 2.
Ag the photo show © 1.Hook the traction wire to the servo cable, and pass it through the vertical tal then install the horizontal tail on the vertical tall and fix i with screws Craw Pasha PCS) 2: Conn act the servo cable to: the. extension cable then install the horizontal vertical sterilizer on the fuselage tail and fx with sons.
As the photo show © 1.Insert the carbon tuba into the main wing, assemble the left and right main wing into one body, and then fix it with screws. Screw (PARS JET 2 Use sorrows fo fx the main wing on the fuselage.
Bhi CT Correct Canter of Gravity (PCG) Is critical for enabling safe aircraft stability and responsive control. Please refer to the following CG diagram to adjust your rafter's Center of Gravity. Depending on the capacity and weight of your choose flight batteries, move the battery forward or backward to adjust the Canter of Gravity. If you cannot obtain the recommended CG by moving the battery to a suitability cation, you can also install a counterweight to achieve comet CG.
ddl Ed After installed the plane, before flying, we need a fully charged battery and connect te the ESC, then use radio fo test and check that every control! surface work properly.
In the PNP version, open the cockpit, you can see 11 unconnected wire ends. Please follow tha label on the connection wire to connect as shown below, The “gs” shaded symbol on the main wing control board indicates that in the PNP version, this channel has been plugged into the cable.