User Manual

A -
B -
C -
D -
E -
F -
G-
H -
I -
J -
K -
L -
M-
N -
O-
R -
Main gear axle
Screw
Rear gear slant supporting rod
Pin
E clip
Main gear trunion A
Screw
Spring
Screw
Main wheel
(M3x3mm)
(Ø3.5X9.2mm 1pc)
(Ø1.5mm 1pc)
(M4x3mm)
(PM3x4 1pc)
Main gear main supporting rod
B
Main gear main rod
Grub screws (M4x4mm)
Retract controller
Nose gear door
Screws (PM2x5 2pcs)
A
B
C
D
E
F
G
S-
T -
U-
Main landing gear set
Screws (FA3x8 4pcs)
Main landing gear mount
S
T
U
1
H
I
J
K
2
M
L
N
3
O
R
4
5
8
MIG-21MF FISHBED
Item No.:F J210
Landing Gear Installation
Rear Landing Gear Assembly
Assemble and disassemble the rear landing gear according to the following photo.
Step
Step
Step
Step
Step
When you use a gyro,
Elevator \ Aileron \ Rudder channels
from the Control Board connect directly
to the gyro outputs, then from the gyro
inputs to the receiver. All the other
channels will connect directly to the
receiver from the Control Board.
Refer to the model of the control board, insert all
the connection cables to the control board.
( Not including throttle, the throttle cable goes directly to
the receiver .)
Control board
Landing Gear
Flap
Landing gear
Rudder
Elevator
Aileron
(power to the receiver)
Landing Gear
Rudder/Nose steering
Elevator
Aileron
Flap
Rudder/Nose steering
Elevator
Aileron
Flap
M
Control Board Introduction and Use