User Manual

6
A
B
C
B
C
A
B
A
C
Ser
v
os
wire
D
Pushrod diameter Ø1 . 5mm
90mm
(3-1/2")
Pushrod diameter Ø1 . 5mm
80mm
(3-1/8")
1
2
3
2
3
1
1
2
3
2
3
1
1
2
3
2
3
1
1
2
3
2
3
1
Pushrod diameter Ø1 . 5mm
158mm
(6-1/4")
Pushrod diameter Ø1 . 5mm
58mm
(2-5/16")
MIG-21MF FISHBED
Item No.:F J210
Servo Installation Instructions
1. Use a servo tester or radio to center the
servo.
2. Use glue to install the servos and control
horns to the main wing.
3.Feed the servo cables through the trough,
after all the cables are in place, apply the
decal over the trough.
4. Feed one end of the pushrod into the
aileron servo arm and adjust its length.
Snap the clevis to the aileron control
horn's ball link.
5. Feed one end of the pushrod into the
flap servo arm and adjust its length.
Snap the clevis to the flap control
horn's ball link.
6. Repeat the above four steps for the
other aileron and flap servo.
Flap and Aileron Servo Installation
A - 9g servo
B - Main wing pushrod
C - Aileron horn
D - Main wing servo trough
Elevator Servo Installation
1.
2.
Use a servo tester or radio to center
the servo arm.
Use glue to intall the servos on the
elevator servo mounts.
3.Feed one end of the pushrod into the
servo arm and adjust its length. Snap
the clevis to the elevator control horn's
ball link.
4.Repeat the above steps to install
the servo on the opposite side.
A - 9g servo
B - Elevator horn
C - Elevator pushrod
1. Use a servo tester or radio to center
the servo arm.
2. Use glue to install the servo to the
Horizontal Stabilizer and the control horn
to the rudder.
3. Feed the servo cables into the trough.
4. Feed one end of the pushrod into the
servo arm and adjust its length. Snap
the clevis to the rudder control horn's ball
link.
A - 9g servo
B - Rudder horn
C - Rudder pushrod
Rudder Servo Installation
Aileron pushrod size
Flap pushrod size
Aileron pushrod mounting hole
Flap pushrod mounting hole
Rudder pushrod size
Rudder pushrod mounting hole
Elevator pushrod size
Elevator pushrod mounting hole