User Manual

3
(Ø8x400mm)
main wing trough port
Intake
Elevator Servo wires
2.Use the steel wire to pull the elevator servo cables to the battery compartment.
MIG-21MF FISHBED
Item No.:F J210
Carbon tube A
(Ø6x345mm)
Carbon tube B
Battery tray
1.Use the provided glue to attach front\rear
fuselage parts.
Screws (KA3x10mm 4pcs)
PNP Assembly Instructions
Steel wire use instructions
Pre- Installation Preparation
1.Open the hatch and loosen the screws which hold the battery tray in
place. Remove the battery tray.
2. Remove the intake plate.
Fuselage Assembly
Main Wing Installation
Back of fuse
l
age
1.Insert the carbon tube A and B into fuselage.
2.insert the main wing servo cables into the fuselage wire trough
and into the ports.
Steel wire
B
a
t
t
e
r
y c
o
m
p
a
r
t
m
e
n
t
Our tests show that excessively long servo extension lines increase the risk of poor connections that can lead to servo
brown outs or failure, causing accidents during flight. Instead, this kit contains a steel wire that can be used to pull the
main wing/elevator and rudder servo wires through the airplane to the battery compartment, eliminating the need for
extension wires.
There is EPO glue provided with the kit. Apply the glue to the fuselage parts and allow it to
sit for 2 minutes. Press the two pieces together several times and allow the glue to get 'stringy'.
Push the two parts together a final time and allow the glue to set.