User Manual
Servo Introduction
A servo or reversed servo is defined as follows:
When the servo input signal changes from 1000ųs to
2000ųs,
if the servo arm rotates clockwise, it's a positive servo.
If it rotates counter clockwise, it's a reversed servo.
EN
If you decide to purchase another brand of servo,
please refer to the following list to ensure that it is
correct size .
1
7
8
9
B
attery Installation
H
Push back the lever to release the Battery
Hatch cover. Place the battery on the deck
and secure it with the Velcro strap.
Power up the radio, check to ensure that
the throttle is in the lowest position.
Engage the kill switch if one is assigned.
Super Scorpion
1.
Use a one to three-wire harness to connect to the No.1
No.8 No.9 servos.
2.
Use Y-wire
harness to connect
to
the No.2 No.3 servos.
3.
Use Y-wire harness to connect to the No.4 No.5 servos.
4.
Use Y-wire harness to connect to the No.6 No.7 servos.
-8-
Our standard battery is,
The recommended battery capacity and discharge rate
advised is :
6S 22.2V 3700mAh ~ 6S 22.2V 5000mAh
Discharge rate of C
30C
Different weight battery may affect its CG, please
the correct range of CG indication.
Ensure that the receiver is bound to the radio!
Follow the instructions in your radio manual.