User Manual
Nose Gear Door Installation
Accessories list
A-Spring
B-Nose cabin door
1.As shown in the photo to the right, snap the "Nose
gear door (B)" to the fuselage.
2.Connect the "Spring (A)".
Main Gear Installation
Accessories list
A-
Electric Retract
B-
Attachment pin
C-
Main gear upper strut
D-
Main gear slant supporting rod
E-
Main gear lower strut
F-
Spring
G-
Wheel shaft
H-
Wheel
I - Pin
J-E-clip
K-
Grub screw (M3x3mm)
L-
Grub screws (M4x3mm 4pcs)
G
H
1
K
3
0
\
Super Scorpion
-7-
1. Insert the "Attachment pin(B)"into the Electric
retract(A)"and use 2 "Grub screws(K)" to secure it.
2. Put the "Main gear upper strut(C)"on the
"Attachment pin(B)"and use 2 "Grub screws(L) to
secure it.
3. Put the "Main gear slant supporting rod(D)"on the
end of the "Main gear upper strut(C)"and use 2
"Grub screws (L)" to secure it.
4. Use "Pin(I)" and "E-clip(J)"to connect the "Main gear
slant supporting rod(D)"to the "Main gear lower
strut(E)"
5. Use 2 "screws(M)"to attach both ends of the
"
Spring(F)"to the "Main gear slant supporting
rod(D)"and the "Main gear upper strut(C)".
Insert
the "Wheel shaft(G)"into the "Wheel(H)"and
then into the hole in the " Main gear lower strut(E)"then
use "grub screw(K)" to secure the "Wheel shaft(G)" to
the Main gear lower strut(E)".
Place the assembled "Main landing gear(Q)"in to the
landing gear hard point and use 4 "Screws(N)" to
secure it to the main wing.
Feed the wires through the wire trough.
Use 1 "Screw(O)"to mount the landing gear door to the
"Main gear slant supporting rod(D)".
Use glue to attach the "Landing gear decal(R)"to the
main wing as shown.
6.
7.
8.
9.
10.