User Manual

Rudder A sse mb ly
1. Center the servo arm with either a
servo tester or your radio.
2. Insert the servo box (E) into the
cavity in the vertical stabilizer.
3. Install the servo (C) inside the
servo box (E).
4. Using 2 screws (A), fasten the
servo cover (B) to the servo box
which will secure the servo to the
Stabilizer.
5. Thread the open end of the control
rod into the servo arm and adjust
the clevis so that the rudder is in
the neutral position when it is
attached.


 all servo boxes are factory installed
so if it becomes necessary to replace a servo,
it will not damaged the foam. If you need to
replace a servo and choose not to use a
Freewing product, please refer to the following
diagrams for the correct size.
 
Drop tank/ scale weapon pylons
F-86 Sabre
  
  
-5-
 


r
EN
8
Rudder push rod size

 
(2.17in)

Rudder pushrod mounting hole
�F

   
1. Attach the rudder to the fuselage.
2. Using 2 screws through the
underside of the fuselage, lock the
rudder in place.
3. Ensure that the screws travel into the
locks correctly to avoid stripping
them.
1. Apply glue to the weapons
pylons and attach them to the
slots on the underside of the
main wing.
2. Pull the parts off slightly and
reapply several times so that
the glue forms strings as you
separate the pylon from the
wing.
3. Allow the glue to set for
approximately two hours to
dry, then install the drop
tanks utilizing the magnets
and the pylons.