User Manual
Main Wing
A
ss
emb
l
y
1.
Use a servo tester or radio to center the
servo.
2.
Use the supplied glue to secure the servo
box
(E)
into the servo hatch.
3.
Install servo
(
C
)
into the servo box
(E)
.
4.
Use 2 screws
(
A
)
to screw the servo cover
T
B
Aileron pushrod mounting hole
EN
I
===
6
=
=
=
=
s
F-86 Sabre
FI a p pushrod mounting hole
Flap pushrod size
Carbon Tube
Main wing plate1
1.
Use the carbon tube to connect the left
and right wings.
2.
Use a Y connector to connect the left
and right flap servos.
3.
Use a Y connector to connect the left
and right aileron servos.
4.
Use a 3 to 1 connector to connect the
left and right main landing gear.
5.
Secure the main wing to the fuselage
and feed the connectors through to the
fuselage so that they can be plugged into
the receiver.
6.
Secure the wing using the plastic wing
plates (1 and 2)
Aileron pushrod size
(B) to the servo hatch (E), thus securing the
servo(C).
5. Feed the open end of the servo pushrod (D)
into the servo arm and adjust the control rod
clevis to the proper length so that at the servo's
centered position, the flap is completely
retracted.
6. Repeat these steps to install the other three
servos to the wing, remember to center the
ailerons and adjust the clevis, so that they are
centered when the clevis is attached to the
control horn and the servo is centered.
N
ote
:
all servo boxes are factory installed so if
it becomes necessary to replace a servo, it will
not damage the foam. If you need to replace a
servo and choose not to use a
F
reewing
product, please refer to the following diagrams
for the correct si
z
e.