User Manual

9. Apply 5-minute epoxy to the bottom of8. Insert the aileron servo wires into the
holes in the fuselage and route them to
the Rx.
the vertical stabilizer with the foam insert on
the right side removed.
10. Carefully install the vertical stabilizer onto the fuselage, making sure the elevator tube
goes into the exit slot. Be sure not to foul the pushrod opening with glue.
11. Epoxy the area where the foam insert goes. Carefully install the insert while making sure the elevator
tube goes into the exit slot.
F9F Panther
Item No.:F1701
-4-