User Manual

Slat Assembly
D2
 
A- Slat pushrod
B - Metal pin
C - E-clip
 
1.Use "Metal pin(B)" and "E-clip(C)" to attach
one side of the slat pushrod to the slat
controller, use "Screw(D)" to attach the other
side to the plastic slat.
 "  m  "  " 
 "  "  " 
 "P  " 
 
 m
 
 h 
Attention:Slat assembly has 6 pieces.
Please refer to the letter in the plastic to
distinguish: L and R refer to the Left and
Right main wing, Figures 1-3 mean the
direction from wing root to wingtip .
Attention: After inserting the plastic pin, melt the other
side using a hot tip such as a soldering iron.
Attention: The slat controller has a left and
right side, please distinguish between the two
1.Use the screws and glue to attach
the assembled slat sets.
2.Use glue to attach the blister cover to
k
eep the surface clean.
Nose Gear Assembl y
Assemble/disassemble the nose gear
b y referring to the following diagrams.
Step 1
T-45 Goshawk


K�
Step2
Accessories name and specifications
A
-
Electronic retract
B -E-clip (02.0mm)
C -Retract pin
D
-
Steering tiller arm
E
-
Steering rod ring
F
-
Steering rod
G-Screw (M3x3mm)
H -Spring
I -Screw (PM2x4mm)
J -Main gear strut
K -Shock absorbing rod
L - Connecting arm 1
M -Screw (M3x5.2mm)
N -Grub screw(M4x4mm)
0 - Nose wheel axle
P -Wheel
(045115mm)
Q -Washer
R -
Connect ing arm 2
S -Screw (PA2x8mm)
T -Plastic retract rod
U -Plastic launching hook
V -Shock absorber supporting rod 2
W -Shock absorber supporting rod 1
x -Pin
Y -Pin
Z - Pin
AA -Pin
AB -Collar
AC -LED landing light

y
u-► 



y
Step 3
Step4
-7-
Screws ( PB2. 6x6mm 16pcs )
Refer to the photo on the right