User's Manual

3. Configuring the WP201-100
Page 43 of 267 LUM0073AA Rev Feb-2017
This document is the property of FreeWave Technologies, Inc. and contains proprietary information owned by
FreeWave. This document cannot be reproduced in whole or in part by any means without written permission from
FreeWave Technologies, Inc.
Figure 41: Wireless window - Operation Mode area
7. In the Operation Mode area:
a. For either the 2.4GHz or 5GHz frequency, click the Operation Mode list box arrow and
select either Mesh-AP or Mesh-Only.
b. For 5GHz: Click the Wireless Mode list box arrow and select:
802.11 B/G/N for 2.4GHz or
802.11 AC/N for 5GHz.
Note: The Wireless Mode list box is NOT available for Mesh-AP 2.4GHz networks.
c. Click the Channel HT Mode list box arrow and select the size of the channel for each
frequency band.
FREEWAVE Recommends: Use a lower Channel HT Mode bandwidth if network
signals are not strong.
d. Click the Extension Channel list box arrow and select either the Upper Channel or
Lower Channel for the designated frequency of the WP201-100.
Note: The Extension Channel option is NOT available if 20MHz is selected as the
Channel HT Mode.
e. Click the Channel list box arrow and select the channel to use for the Wi-Fi from the
WP201-100.
f. Click the Transmit Power list box arrow and select the power output of the wireless
signal from the WP201-100.
Important!: The Transmit Power list box is not available if the Channel list box
selection is Auto.
DRAFT