User's Manual

WavePro™ WP201 Access Point: User Manual
3.2. Mesh-AP or Mesh-Only Configuration
This procedure configures the WP201-100 as a Mesh Access Point.
Example: See either the Mesh-AP Mode (on page 135) or Mesh-Only Mode (on page 136) for
examples of an Mesh - AP network setup.
Procedure
Note: This example procedure uses Mesh-AP.
The procedure is the same for Mesh-Only except where noted.
1. Connect to the WP201-100 Access Point (on page 19).
2. Change the Setup the Computer IP Address Configuration (on page 21).
3. Access the WP201-100 (on page 24).
4. In the WP201-100 Access Panel, click Wireless.
The Wireless window opens.
Note: See the description of the Wireless window (on page 191) for detailed information about
the options in the window.
Figure 40: Wireless window - Wireless Settings area
5. In the Device Name text box, enter a name for the WP201-100.
Important!: The Country / Region is set at the factory and cannot be changed by the user.
Note: Band Steering cannot be enabled in a Mesh network.
6. Scroll to the Operation Mode area.
Note: See the description of the Operation Mode area (on page 193) for detailed information
about the options in this area.
LUM0073AA Rev Feb-2017 Page 42 of 267
This document is the property of FreeWave Technologies, Inc. and contains proprietary information owned by
FreeWave. This document cannot be reproduced in whole or in part by any means without written permission from
FreeWave Technologies, Inc.
DRAFT