User's Manual

12. WP201-100 Release Notes
Page 251 of 267 LUM0073AA Rev Feb-2017
This document is the property of FreeWave Technologies, Inc. and contains proprietary information owned by
FreeWave. This document cannot be reproduced in whole or in part by any means without written permission from
FreeWave Technologies, Inc.
l MAC address filtering increased to 50 entries – white or black list.
PTP Link Performance and Operation
l Enable 5G RTS/CTS to enhance long distance PTP link performance
l Change Channel HT Mode default value to 20MHz to optimize for noise floor
Mesh Networking
l WMM support when WDS and Mesh networking
l VLAN support when WDS and Mesh networking
l Corrected cross band VLAN pass through – need to enable Cross Band VLAN Pass
Through on Wireless page
Corrections
l Corrected the Connection Page operation and reporting.
l Corrected WDS-STA behavior change issue – cache clearing.
l Set Mesh RSSI range to be consistent with its warning message's range (-85dBm to -
65dBm).
l Corrected Lua errors when applying changes and reloading WebGUI.
l Fixed low data rate over 5GHz link.
l Implemented a Reset Transmit Queue function to fix the WLAN transmit queue leak.
l RADIUS client now connects AP properly.
l Corrected operational inconsistencies when using Windows® Edge and Internet Explorer®
11.
l Corrected WebGUI so Microsoft® Edge can now upgrade/load software.
Known Limitations and Workarounds
l 2.4GHz MESH does NOT interoperate with v2.0.8.
l MESH supports either 2.4GHz or 5GHz at the same time.
l WMM in MESH 2.4GHz HT40 does not work.
l When upgrading to new firmware, clear the browser cache.
l If the cache of browser is not cleared, the word Green appears.
l OGM rate is still 54Mbps.
l After resetting to the default, the default value is changed for TQ Assist and Link
Timeout.
l VLAN Tag through 5GHz AP has some problems.
DRAFT