User's Manual

WavePro™ WP201 Access Point: User Manual
Wireless window - Operation Mode area
Control Area Control Title Control Description
Channel HT
Mode list box
Click the Channel HT Mode list box arrow and select the size
of the channel for each frequency band.
FREEWAVE Recommends: Use a lower Channel HT
Mode bandwidth if network signals are not strong.
Note: The available selections depend on the selection
made in the Operation Mode list box.
The options are:
l 2.4GHz
l 20 MHz (the default)
l 20/40 MHz
l 40 MHz
l 5GHz
l 80MHz (AC Only)
l 40MHz
l 20MHz (the default)
The larger the channel, the greater the
transmission quality and speed.
Extension
Channel list
box
Click the Extension Channel list box arrow and select either
the Upper Channel or Lower Channel for the designated
frequency of the WP201-100.
Note: The Extension Channel option is NOT available
if 20MHz is selected as the Channel HT Mode.
Channel list
box
Click the Channel list box arrow and select the channel to use
for the Wi-Fi from the WP201-100.
Transmit Power
list box
Click the Transmit Power list box arrow and select the power
output of the wireless signal from the WP201-100.
Note: The Transmit Power list box is not available if the
Channel list box selection is Auto.
Important!: The maximum output is 23dBm even though
a larger output can be selected in the list box.
LUM0073AA Rev Feb-2017 Page 194 of 267
This document is the property of FreeWave Technologies, Inc. and contains proprietary information owned by
FreeWave. This document cannot be reproduced in whole or in part by any means without written permission from
FreeWave Technologies, Inc.
DRAFT