User's Manual

7. Administration
Page 128 of 267 LUM0073AA Rev Feb-2017
This document is the property of FreeWave Technologies, Inc. and contains proprietary information owned by
FreeWave. This document cannot be reproduced in whole or in part by any means without written permission from
FreeWave Technologies, Inc.
7.17. Wireless MAC Filter - Activate and Define
1. Connect to the WP201-100 Access Point (on page 19).
2. Access the WP201-100 (on page 24).
3. In the WP201-100 Access Panel, click Wireless.
The Wireless window opens.
Note: See the description of the Wireless window (on page 191) for detailed information about
the options in the window.
4. In the Wireless Settings area, click the Edit button.
The Wireless Edit dialog box opens.
5. Scroll to the Wireless MAC Filter area.
Note: See the description of the Wireless MAC Filter area (on page 214) for detailed
information about the options in that area.
6. Click the ACL Mode list box arrow and select Allow MAC in the list to activate Wireless
MAC Filter in the WP201-100.
Figure 152: Wireless Edit dialog box - Wireless MAC Filter area
7. In the MAC Address text box, enter the MAC address of the other WDS nodes.
8. Click the Add button to add the MAC address to the MAC address table.
The Wireless Edit dialog box refreshes showing the added MAC address in the Wireless
MAC table.
9. Click Save to save the changes.
The Wireless Edit dialog box closes.
The Wireless window returns.
The Changes tab shows the accumulated number of pending changes ready to apply.
DRAFT