User's Manual

WavePro™ WP201 Access Point: User Manual
7.12. Setup of IPv6 Settings
1. Connect to the WP201-100 Access Point (on page 19).
2. Access the WP201-100 (on page 24).
3. In the WP201-100 Access Panel, click Basic.
The Basic window opens.
Note: See the description of the Basic window (on page 152) for detailed information about
the options in the window.
Figure 141: Basic window - IPv6 Settings area
4. In the IPv6 Settings area:
a. Clear the Link - Local Address check box to activate the IPv6 Settings area.
b. In the IP Address text box, enter an IP Address that is
in the same subnet range but a DIFFERENT IP Address than the WP201-100
AND
different than the computer IP Address.
Note: Specify a routable IPv6 IP Address.
c. In the Subnet Prefix Length text box, enter the slash number (e.g., /23).
d. In the Gateway text box, enter the Default Gateway of the WP201-100.
FREEWAVE Recommends: Leave the Gateway text box blank if this setting is not
known.
e. In the Primary DNS text box, enter the primary DNS address for either the IPv4 or
IPv6 WP201-100.
f. In the Secondary DNS text box, enter the secondary DNS address for either the IPv4
or IPv6 WP201-100.
5. Scroll to the bottom of the Basic window.
LUM0073AA Rev Feb-2017 Page 119 of 267
This document is the property of FreeWave Technologies, Inc. and contains proprietary information owned by
FreeWave. This document cannot be reproduced in whole or in part by any means without written permission from
FreeWave Technologies, Inc.
DRAFT