User's Manual

7. Administration
Page 116 of 267 LUM0073AA Rev Feb-2017
This document is the property of FreeWave Technologies, Inc. and contains proprietary information owned by
FreeWave. This document cannot be reproduced in whole or in part by any means without written permission from
FreeWave Technologies, Inc.
Figure 137: Time Zone window
4. Click the Time Zone list box arrow and select the time zone the WP201-100 is located in.
5. If applicable, select the Enable Daylight Saving check box if daylight savings applies to
the area the WP201-100 is located in.
Note: If the Enable Daylight Saving check box is selected, the Daylight Savings Time -
Start Time and End Time are required.
6. Click the respective Start Time list box arrows and select the Month, week of the month,
Day of the week, and Time when Daylight Savings Time starts in the selected Time
Zone.
Example: If Daylight Saving Time starts at midnight on the first Monday of March, the
selections are: March, 1st, Mon, 12am.
7. Click the respective End Time list box arrows and select the Month, week of the month,
Day of the week, and Time when Daylight Savings Time ends in the selected Time
Zone.
Example: If Daylight Saving Time ends at midnight on the first Sunday of November, the
selections are: November, 1st, Sun, 12am.
8. Click Apply to save the changes.
DRAFT