User's Manual

7. Administration
Page 110 of 267 LUM0073AA Rev Feb-2017
This document is the property of FreeWave Technologies, Inc. and contains proprietary information owned by
FreeWave. This document cannot be reproduced in whole or in part by any means without written permission from
FreeWave Technologies, Inc.
e. In the Username text box, enter the username for the e-mail account used to send e-
mails.
f. In the Password text box, enter the password for the e-mail account used to send e-
mails.
g. In the SMTP Server text box, enter the IP address or host name of the outgoing SMTP
server.
h. In the SMTP Server Port text box, enter the SMTP port number to use for outbound e-
mails.
i. Click the Security Mode list box arrow and select either None, SSL/TSL, or
STARTTLS.
j. Click the Send Test Email button to send a test e-mail to the e-mail address in the
Status - To text box.
k. Click Apply to save the changes.
6. Scroll to the bottom of the Advanced window.
7. Click Apply to save the changes.
The Advanced window returns.
The Changes tab shows the accumulated number of pending changes ready to apply.
Figure 129: Changes tab showing the number of changes to apply.
8. Click the Changes tab.
The Unsaved window opens.
Important!: The change count and the changes listed in the image are examples only. The list
identifies different information depending on the changes applied to the WP201-100.
Figure 130: Unsaved window showing changes to apply.
9. Click Apply to integrate changes identified in the Unsaved Changes List to the WP201-
100.
A Processing bar appears.
When the processing is completed, the Device Status window opens.
10. If applicable, continue with other changes for the WP201-100.
DRAFT