User's Manual

WavePro™ WP201 Access Point: User Manual
7.6. Define a WPA-PSK Security Mode
1. Connect to the WP201-100 Access Point (on page 19).
2. Access the WP201-100 (on page 24).
3. In the WP201-100 Access Panel, click Wireless.
The Wireless window opens.
Note: See the description of the Wireless window (on page 191) for detailed information about
the options in the window.
4. In the Wireless Settings area, click the Edit button.
The Wireless Edit dialog box opens.
Note: See the description of the Wireless Edit dialog box (on page 208) for detailed
information about the options in the dialog box.
5. Click the Security Mode list box arrow and select WPA-PSK.
Figure 125: Wireless Edit dialog box - Security Mode = WPA-PSK
6. Click the Encryption list box arrow and select the encryption type to use.
Important!: All wireless clients MUST use the same settings.
7. In the Passphrase text box, enter the phrase wireless clients must use to access the
WP201-100.
Important!: All clients MUST use the same Passphrase to connect with the WP201-100.
l If using an ASCII format, the Passphrase must have a minimum of 8 characters and a
maximum of 63 characters in length.
l If using a HEX format, the Passphrase must be 64 HEX characters in length.
8. In the Group Key Update Interval text box, enter how often, in seconds, the Group Key
changes.
9. If required, scroll to the bottom of the Wireless Edit dialog box.
LUM0073AA Rev Feb-2017 Page 107 of 267
This document is the property of FreeWave Technologies, Inc. and contains proprietary information owned by
FreeWave. This document cannot be reproduced in whole or in part by any means without written permission from
FreeWave Technologies, Inc.
DRAFT