User's Manual

WavePro™ WP201 Access Point: User Manual
Figure 119: Wireless Edit dialog box for a Guest Network
7. Click the Encryption list box arrow and select the encryption type to use.
Note: The default is Both (TKIP + AES).
Important!: All wireless clients MUST use the same settings.
8. In the Passphrase text box, enter the phrase wireless clients must use to access the
WP201-100.
Important!: All clients MUST use the same Passphrase to connect with the WP201-100.
l If using an ASCII format, the Passphrase must have a minimum of 8 characters and a
maximum of 63 characters in length.
l If using a HEX format, the Passphrase must be 64 HEX characters in length.
9. In the Group Key Update Interval text box, enter how often, in seconds, the Group Key
changes.
10. Click Save to save the changes.
The Wireless Edit dialog box closes.
The Wireless window returns.
The Changes tab shows the accumulated number of pending changes ready to apply.
Figure 120: Changes tab showing the number of changes to apply.
11. Click the Changes tab.
The Unsaved window opens.
Important!: The change count and the changes listed in the image are examples only. The list
identifies different information depending on the changes applied to the WP201-100.
LUM0073AA Rev Feb-2017 Page 103 of 267
This document is the property of FreeWave Technologies, Inc. and contains proprietary information owned by
FreeWave. This document cannot be reproduced in whole or in part by any means without written permission from
FreeWave Technologies, Inc.
DRAFT